Aqua One AquaReef 200, Инструкция по эксплуатации

Страница: 8 / 10

AquaReef 200
Main Tank Installation:
Step 1: Once all the equipment has been unpacked and installed the aquarium can be filled with water.
Step 2: Fill up the main aquarium. When water enters the filter via the weir check the filter is filling with water.
Step 3: When the water level in the filter is above the sponges in the third chamber the return pump can be switched on.
Step 4: Moniter the water level in the filter as the water is circulating, as a top up may be needed.
Step 5: Once the aquarium is up and running the skimmer can be turned on.
Once the aquarium has been filled turn the skimmer on and it will fill up with water.
- Once the skimmer is working the outlet tap can be used to raise and lower the water level in the filter.
- The venturi adjuster can also limit the amount of air which enters the skimmer.
- There needs to be a fine balance between water entering the skimmer and the amount of air.
- By adjusting the venturi valve and the outlet valve you need to set the water level at the base of the collection cup.
- The air can be adjusted, to move the water level further up the collection cup.
Ideal water level
in the filter
Ideal water level
in the skimmer