Aqua One AquaReef 200, Инструкция по эксплуатации, Страница: 6 / 10

AquaReef 200
Light Unit Installation:
Step 1: Remove the light units and flap sets from the boxes.
Step 2: There are 2 different light units, one is T5 which is positioned at the front of the aquarium. The second is T8 with
one tube smaller than the other should be positioned at the rear, the shorter (lower output) tube is designed to be over the
refugium filter.
Step 3: Line up the first light with the two edges of the aquarium and it will sit in place, repeat this process with the second
light unit, making sure the smaller bulb is at the back.
Step 4: Feed the cables through the hole provided on the back of the aquarium.
Step 5: Take the first flap and insert the two pins into the light unit. The flap should push forward and sit flat.
Step 6: Take the second flap and insert two pins into the back of the first light unit, the second flap will now sit flat.
Step 7: Take the second light unit and tilt it forward this will enable you to fit the middle flap to the second light unit.
Step 8: Repeat step 5 to fit the remaining back flap
Step 9: Plug into the power supply and switch on both light units.
Note: Ensure all aluminium reflectors are above the light tubes and can therefor reflect the light back into the
aquarium.
1
1
2
2
3
3
Front light unit
Rear light unit
(Short tube should be over the filter unit)