Aqua Comfort ACT-1100T5S ACT-1250T6S, Руководство пользователя

Страница: 2 / 13

2
SAFETY CONSIDERATIONS
• Qualified personnel should perform installation, maintenance and service.
• Make sure all field wiring conforms to the heater specifications and all national and local
codes.
• Disconnect all power sources before performing any maintenance or service to the heater.
INSPECTION
Immediately upon receipt, inspect cartons and their contents for damage due to transit.
Damage, if found, should be noted on delivery papers and a claim filed with the carrier. Also,
check unit data plate to make sure you have the proper model, before installing.
GENERAL INFORMATION
The information in this manual was prepared to assist in the proper installation, operation,
maintenance and service of your new heat pump pool heater. Please read the entire manual and
follow all instructions. Improper installation and use can result in damage to the heater,
unsatisfactory operation, and may void the warranty. Retain this manual for quick reference.
INSTALLATION
When selecting a location consider the following:
• Heater must be located outdoors.
• Minimum of 24” of clearance on access / service side of heater.
• Minimum of 18” of clearance on all three air intake sides of heater.
• Minimum of 48” of clearance for air discharge (top of unit).
• The heater should sit on a solid level surface sufficient above grade to prevent water from
entering it, and allowing condensate to drain from base.
• The length of water piping and electric should be kept to a minimum to avoid capacity
loss and decreased efficiency.
WATER FLOW & CONNECTIONS
Water connections are made at the front or rear of the heater. Water in and out is labeled at the
connections. Unions are supplied and are made to accept either 2” or 1 ½” rigid PVC pipe. The
minimum flow rate is 20 GPM and the maximum flow rate is 70 GPM.
NOTE: Unions can be used for quick drainage of your heater and winterizing .
• Heater must be piped downstream from filter in the pool return line.
• When all the plumbing connections are complete, and ample drying time is allowed, run
the filter pump and check the entire system for water leaks.
• Make sure filter is clean and there are no obstructions in the filtering system.
• Proper water flow is essential to the performance of your heat pump.
• The minimum flow rate is 20 GPM.