Aqua-Air Wet/Dry 130, Руководство пользователя

Страница: 18 / 23

16
3. In heavy soil conditions a deck/scrubbing brush should be used to
scrub solution and soil on the floor.
4. Using the wand with commercial brush and squeegee attachment,
spray floor with rinse water and squeegee dry. Repeat as necessary.
Note; If your system has been installed with the chemical injector
(AA031 or AA033), then the rinse water should be mixed with multi-
surface cleaner (SC05GL). This will increase cleaning, odor control
and help keep the vacuum piping and power unit fresh.
5. Tile and grout will be clean and instantaneously dry.
CLEANING PROCESSES & PROCEDURES
Linoleum, Vinyl, Stone, Concrete etc.
All of these surfaces can and should be cleaned using the Aqua-Air Wet/Dry ®
process. These surfaces should be cleaned using the "hard- wood" or "tile &
grout" procedures previously outlined. The procedures should vary slightly
from those printed, depending on location and soil conditions.
Auto Interior Carpet & Upholstery
The same procedures should be followed for either private use or service
performed by a professional.
Steps:
1. Thoroughly dry vacuum carpet and upholstery. Use crevice tools
etc. to reach soil. Note; Auto interiors are usually heavily soiled and
wetting unvacuumed dry soil, turns it to mud and makes it more
difficult to remove. Pre-vacuum well!
2. Generously pre-spray carpet & upholstery with commercial heavy-
duty pre-spray (SC02GL). Dilute per instructions.
3. Allow to dwell 15-20 minutes to break down soils. Agitating with
scrub brush may accelerate this process.
4. Using your Aqua-Air Wet/Dry ® upholstery tool. Spray hot/warm
rinse and extract using a forward & back motion until clean. Re-
vacuum same area to pick as much soil moisture as possible.
5. Allow drying. Use fans to accelerate drying.
6. Apply “Carpet Protector” to carpet and fabric seats per instructions.