Aqua-Air Wet/Dry 130, Руководство пользователя

Страница: 14 / 23

Dry Vacuuming
1. Attach the curved wand of the dry vacuum hose to the dry vacuum
tool to be used.
2. Insert the hose cuff with the metal end into vacuum inlet valve.
This will automatically turn on the system (hose with on/off switch
on handle must be turned on to operate).
3. Proceed to vacuum.
Wet Cleaning
1. Attach the curved wand of the wet vacuum hose to the wet vacuum
tool to be used.
2. Attach the water line on the tool by inserting the end in the coupling
and turning one quarter turn to secure on the residential tools.
3. Connect the water line on the vacuum hose to the water outlet quick
coupling (located next to your vacuum inlet or on an extension hose
installed for this purpose) by pressing back the outer ring on the
socket and inserting the water hose end into the quick coupler
socket.
4. Insert the hose cuff with the metal end into vacuum inlet valve. This
will automatically turn on the system.
5. Pre-spray surface to be cleaned with appropriate cleaning
compounds.
6. Cleaning procedure:
• Dry vacuum all surfaces.
• Pre-spray surfaces to be cleaned.
• Use spot cleaners and scrub difficult soiled areas and stains.
• Rinse with water by pressing trigger on curved wand and
vacuum dry.
7. When cleaning is completed, rinse hose and tools by sucking up
water from a pail or sink, then allow vacuum to run for a few
minutes to dry out hose and line.
8. Wipe off tools and hose and hang up hose hanger to avoid any
sharp bends.