20
CAUTION!
Only tighten the nut far enough so that the washers are resting on the spring assembly. In no
case should a gap be produced between the half shells due to excessive tightening.
8.5
REPAIRS AND SERVICE
In case of failure or damage to the implement, please contact the manufacturer. The contact data can be
found in chapter 3.
9
INFORMATION ON NATURE CONSERVATION AND
ENVIRONMENTAL PROTECTION
Reduction of noise pollution during use
Any loose parts (e.g. chains) should be attached to prevent unnecessary noise.
Energy-efficient use
The tines of the implement should not penetrate into the field deeper than necessary. By doing so, the
towing vehicle is not unnecessarily strained and fuel can be saved.
Recyclable raw materials during disposal
Many parts of the implement are made of steel or spring steel (such as the centre frame, side frame, tine
section, tines, ...) and can be accepted and recycled by a waste disposal plant.
10
TECHNICAL DATA
Type designation
VS 600 M1
VS 750 M1
VS 900 M1
VS 1200 M1
Mode of action
With its unique tine spring system, the Tined Weeder Pro is a crop
cultivation implement that adapts precisely to the ground. The harrow
tines can be lifted and are pivot-mounted, so that the harrow can only
deflect up and down, not to the left and right.
Working width [m]
6.2
7.6
9.2
12.2
Transport dimensions,
folded [L x W x H in m]
2.40 x 3.00 x
2.85
2.40 x 3.00 x
3.55
2.40 x 3.00 x
3.55
2.40 x 3.00 x
3.55
Working depth
0-30 mm (depending on the soil conditions)
Number of tines [units]
178
218
264
350
Tine diameter [mm]
8
Tine length [mm]
520
Line distance [mm]
35
Mounting/hitch (three-
point, …)
Mounting
– CAT 2 / CAT 2N
Feeler wheels, standard
equipment [unit]
4
4
4
6 S
Net weight [kg]
900
1050
1300
1550
Parking supports
2 supports, if no feeler wheels are used at the rear
Working tools
Cranced tines with a diameter of 8 mm
Ground adaptation
Is achieved through the unique tine spring system
