APRILIA TUONO 1000 R, Руководство по ремонту

Страница: 61 / 279

FUEL SYSTEM
3 - 11
TUONO 1000
SCREEN DESCRIPTION
APPROXIMATE
VALUES
UNIT
OF
MEASURE
NOTE
Initialisation fault
no/engine speed>0/ vehicle
speed>0/ stepper error/ throttle
position / battery voltage/ water
temperature / stepper motor off
Possible factors that may have caused
unsuccessful Throttle position learning
or Initialisation, in this order: Engine
speed>0/Vehicle speed>0/stepper
motor error/Incorrect throttle
position/Incorrect battery voltage
/Water temperature /Stepper motor
disconnected
Lambda control
initializ./Wait.after
start/Ric.st.lambda/Att.after
ric/Dis.for rid./Dis. for err/Att.after
int/Lambda act/Saturat.
Current lambda sensor conditions
Engine variant 1/2 -
1 if standard mapping is active, 2 if
Racing mapping is active -necessary
when using non-approved exhaust
pipes
Injectors per cylinder 1cyl -
ECU status that cannot be changed:
should read "1cyl"
Knock sensor No -
ECU status that cannot be changed:
should read "no"
Boost adjustment No -
ECU status that cannot be changed:
should read "no"
Lambda sensor Yes -
ECU status that can be changed with
password authority only; should usually
read "YES", i.e. lambda sensor
available
Water injection No -
ECU status that cannot be changed:
should read "no"
Idling mot. fitted Yes -
ECU status that can be changed with
password authority only; should usually
read "YES", i.e. stepper motor available
Purge valve yes/no -
Parameter not active (mechanical
purge valve)
Electronic reverse No -
ECU status that cannot be changed:
should read "no"
Electric starting Yes -
ECU status that cannot be changed:
should read "yes"
Initialised ECU yes/no
If status is "yes", it indicates that the
parameter "Initialised ECU" was
activated. If the ECU needs replacing,
this parameter should be activated or
the engine rpm will be limited
ENABLE
DEVICES
Delete errors - -
Press ENTER to switch error status
from memorised (MEM) to deleted
(STO). The next time Axone is
connected to the ECU, the deleted
errors (STO) will no longer be displayed
Fuel pump - -
The device is activated: if not correctly
activated, the tester will NOT show
failed activation immediately; it is
necessary to check the detected faults
page
Lambda sensor heating - -
The device is activated: if not correctly
activated, the tester will NOT show
failed activation immediately; it is
necessary to check the detected faults
page
Fan - -
The device is activated: if not correctly
activated, the tester will NOT show
failed activation immediately; it is
necessary to check the detected faults
page