APRILIA SR 50 - 2001, Руководство пользователя, Страница: 82 / 104

82
use and maintenance SR 50
Depending on the beam adjustment to be
carried out, select:
– the group necessary for the adjustment;
– the direction (to the right or to the left).
NOTE
Use shims and screws of the
same group.
♦ Insert the shims in the headlight screw
seats as indicated in figures A and B:
– rightwards (figure A);
– leftwards (figure B).
♦ Position the headlight (3) in its seat.
♦ Screw and tighten finger tight the lower left
screw (1) (in the seat without shim).
NOTE
Replace the screws (2) with the
specific screws corresponding to each
shim.
Take the screws (2) and keep them in the
kit.
BULBS
Carefully read p. 55 (MAINTENANCE).
Risk of fire.
Keep fuel and other flammable
substances away from the electrical
components.
Before changing a bulb, turn the ignition
switch (4) to the “
” (OFF) position and
wait a few minutes so that the bulb cools
down.
Change the bulb wearing clean gloves or
using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
TAKE CARE TO AVOID DAMAGING THE
ELECTRIC CABLES.
♦
Screw and tighten finger tight the three
screws (specific for each shim) (see table).
♦
Tighten the four screws.
♦
Make sure that the horizontal adjustment
of the headlight beam is correct.
♦
Replace the front inner shield, see p. 73
(REMOVING THE FRONT INNER
SHIELD).
♦
Replace the front shield cover, see p. 68
(REMOVING THE FRONT SHIELD
COVER).
♦
Make sure that the vertical adjustment of
the headlight beam is correct, see p. 80
(ADJUSTING THE HEADLIGHT BEAM
VERTICALLY).
CAUTION
WARNING
2
2
2
3
1
1
2