Appro VS-2401, Руководство по установке и эксплуатации

Страница: 13 / 100

6. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on
a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical
support while ignoring the following steps.
7. DO NOT power off the Video Server while this update process is running until the message
"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to
appear.
8. If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET
PLEASE", please write down the error messages shown on the screen and inform your
technical support, while ignoring the following steps.
9. Power off the Video Server when this update process is finished, then remove the SD card from
the Video Server.
10. Reconnect the Ethernet cable to the RJ-45 port if necessary.
11. Power ON the Video Server and it will work normally if the entire update procedure goes
correctly.
12. Verify the version of the system software.
WARNING
:
Steps 1 to 2 have to be done on a PC.
Make sure the file of UPDATE.BIN is a correct one in step 2, or the Video Server will
not work normally after being updated.
If the power of the Video Server is suddenly lost in step 7, please remove the SD card
first and turn on the Video Server next to test its operation. If the Video Server
remains working normally, please go back to step 3; otherwise, please inform your
technical support.
In step 9, if the SD card is not removed and the Video Server does not get online as
well, the updating process must be repeated again after rebooting the Video Server.
Make sure that the SD card is inserted in a correct position in step 4, or the Video
Server will suffer permanent physical damage.
If the message "CSUM ERROR" appears in step 7, it implies a problem in the file of
UPDATE.BIN.
Don’t interrupt the process while the unit is updating itself; proceed with an SD
card not including any system software of the unit, or else the unit will crash.
11