Applied Air GAS-FIRED HEATERS, Инструкция по установке и эксплуатации

Страница: 3 / 64

– 3 –
SECTION II - GENERAL INFORMATION
A. Purpose
The purpose of this manual is to present a guide for
proper installation, maintenance, and operation of the
Indirect Gas-Fired System, and supplement,
but not to
replace , the services of qualifi ed fi eld service personnel
to supervise the initial start-up and adjustment of the
unit. Persons without previous experience with large
commercial and industrial heating equipment should not
attempt the initial adjustment and checkout procedure,
which is essential before such installations may be
considered ready for operation. This manual should be
made readily available to all operating personnel as an
aid in troubleshooting and proper maintenance. Due
to the custom nature of Applied Air equipment, not all
possibilities are addressed in this manual. The customer
or installer can obtain information from Applied Air’s
sales representative or the Applied Air factory.
WARNING: Failure to comply with general safety
information may result in extensive property
damage, severe personal injury or death.
B. Shipping
Base Indirect Gas-Fired units are shipped completely
assembled where shipping limitations allow. Optional
inlet hoods, fi lter and /or damper sections, or other
large accessories are assembled and shipped mounted
and wired whenever possible within limitations of
shipping and handling. Some optional accessories
shipped separately may require fi eld assembly. Any
wired accessories, which have been disassembled for
separate shipment, require no additional conduit or wire
for fi eld reassembly. All wire leads will be tagged for
ease of reconnection in the fi eld.
If the heater and/or accessories cannot be installed
immediately, they should be stored in a clean
dry environment. If this is not possible and the
heater must be stored outdoors, it should be
protected from the weather with tarpaulins or
plastic coverings. Rotate the fans monthly.
Prior
to beginning installation of a unit that has been
in storage for weeks or months, the unit and its
components should be closely inspected.
Prior to beginning installation of a unit that has been
in storage for weeks or months, the unit and its
components should be closely inspected.
Shipments are made F.O.B. Dallas, Texas by truck.
The unit is securely strapped, tied, and blocked to
prevent shipping damage. All shipments are checked
by an inspector before they are accepted by the carrier.
Parts that are shipped un-mounted are noted on the bill
of lading. These parts, where feasible, are packaged
and shipped with the units. Upon receipt of shipment,
all units should be checked against the bill of lading
to insure all items have been received. All equipment
(and any optional accessories) should be checked
carefully for physical damage in the presence of the
carrier’s representative. If parts are missing or damage
has occurred, a claim should be fi led immediately with
the carrier.
All Indirect Gas–Fired units are given a complete
operations test and control circuit checkout before
shipment. Copies of the wiring diagram, piping diagram
and bill of material are included with each unit shipped.
If correspondence with the factory is necessary, please
provide the unit model and serial number.
C. Optional Factory Service
Periodic service on any piece of mechanical equipment
is necessary for efficient operation. A nationwide
service support network is available to provide quick
and dependable servicing of make-up air, heating,
ventilating, or air handling types of equipment. The
factory also offers start-up service, which includes the
presence of a service engineer to supervise the initial
start-up and adjustment of the equipment and provide
instructions for the owner’s maintenance personnel in
proper operations and maintenance. Consult factory for
quotations on periodic or start-up service.