RoadRunner HD™ | High Definition Mobile Recorder
9
Chapter 3
— Operation and Configuration
NOTE: The Recorder should be completely installed before proceeding. Refer to
Chapter 2
— Installation
.
Turning on the Power
The Recorder can be turned on by inserting the key in the On/Off switch and rotating it clockwise. The switch can be
in the On position and the key removed. This way the Recorder will power up when the ACC pin on the Power
Connector – J1 is enabled. The Recorder is operational in approximately 60 seconds. The Recorder will take an
additional 30 seconds to become operational if the “
Use 30 seconds Delayed Start
”
feature is enabled (Path:
System
menu >
Power Management
). The Power LED on the front panel will illuminate and this action signifies the Recorder
has been turned on properly.
NOTE: The Recorder will not power up in the following conditions:
If the temperature is 32°F (0°C) or lower. Refer to
Chapter 2
— Installation
for details.
The battery power voltage is out of the range set during
System menu
>
Power Management
.
There is 2.5V or more voltage difference between the accessory and battery power.
If the Recorder turns off due to an emergency shutdown or shutoff and the battery power voltage
does
not remain within the specified range for longer than the specified time (Path:
System menu
>
Power Management)
. Refer to
Turning off the Power
for details about the emergency shutdown or
shutoff.
CAUTION: Turn on the ignition switch first and then power On/Off switch in about two seconds. If
Use 30 seconds Delayed Start
feature is enabled and you turn on the ignition switch and
then power On/Off switch in less than two seconds, the Recorder may delay to start the
system for 30 seconds after the ignition switch is turned on.
WARNING: D
O NOT TOUCH THE BOTTOM OR TOP OF THE REMOVABLE DRIVE WHEN
REMOVING
IT AFTER THE HEATER HAS BEEN OPERATING IN LOW TEMPERATURES
. DURING
OPERATION OF THE HEATER, THE TEMPERATURE OF THE
DRIVE MAY INCREASE
CAUSING
INJURY.
Turning off the Power
The Recorder can be turned off by rotating the key counter-clockwise to the Off position. The recorder powers off in
maximum 20 seconds when the key is turned to the Off position.
The recorder can also be turned off by inactivating the ACC pin on the Power Connector – J1. When using the ACC
pin the Recorder will shut off after the ignition off timeout if the ignition off timeout feature is set to On (Path:
System
menu >
Power Management
).
NOTE:
The Recorder will automatically turn off to prevent the system from being damaged in the following
conditions:
The battery power voltage registers between 7V to 9V or 36V to 38V for 10 seconds.
The battery power voltage is lower than 7V or higher than 38V for one second.
There is 2.5V or more difference between the accessory input and battery power input on the J1 power
connector.
Содержание RoadRunner HD
Страница 1: ......
Страница 2: ......
Страница 6: ...User Guide and Instruction Manual iv...
Страница 8: ...User Guide and Instruction Manual 2...
