4
OVEN START-UP
When you first plug in the microwave oven to the wall outlet
the display will show a colon:
INTERFERENCE WARNING
Microwave ovens generate radio frequency energy during
operations and if not installed properly, may cause interfer-
ence to radio and television reception. You can determine
if this unit is causing interference by turning it on and off
while the interference is occurring. If interference occurs it
may be corrected by one or more of the following measures:
If the interference persists, you may want to consult an
experienced radio/television technician for additional
suggestions.
INSTALLATION
This oven was carefully packed and shipped in good
condition. If you find shipping damages, notify the dealer
immediately.
Remove all packing materials both outside and inside the
oven before using it.
This High Speed Oven was designed for household use only.
It is not intended for commercial or Industrial use.
The oven requires free movement of air for proper
operation.
DO NOT BLOCK AIR VENTS
located on the back
underneath, or sides of the oven.
Do not remove the feet from the bottom of the oven.
Only models numbers with a BI or OTR suffix can be built-in.
All other models must be installed on the counter top
POWER SUPPLY &
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
This appliance is equipped with a grounding plug. Counter
top models must be plugged into a separate 120W15
ampere outlet served by a 20 ampere branch circuit. Built-In,
Over the Range and Range models require a 20 ampere
outlet served by a 20 ampere branch circuit. Outlets must be
properly installed and grounded in accordance with
applicable electric codes. If your model requires a 20
ampere outlet and you do not have one, contact an
electrician or call
1-800-330-9707
.
For proper operation, no
other appliance should be plugged into the same branch
circuit as the High Speed Oven.
1.
2.
To set the Clock: Touch Clock; Enter the current time of
day by touching the correct number pads. You must
set at least 3 digits (
one for hour(s) and two for minutes
).
For minutes less than 10, precede the “minutes” digit by
a 0. Example: for 5 minutes after 2, set 2:05. The colon
will flash between hour and minute and minute digits.
Touch the start/stop pad to lock in the time. The colon
will stop flashing and the clock has been set and will
begin to keep current time.
The word
“Clock”
will always show on the display unless
the oven is in a Cooking or Timer operation.
A.
B.
Relocate the TV, radio or High Speed Oven.
Plug the oven into a different outlet so that it and the
TV receiver are on different circuits.
INSTALLATION
WARNING
TO PROVIDE CONTINUOUS PROTECTION AGAINST ELECTRICAL SHOCK,
CONNECT TO PROPERLY GROUNDED OUTLETS ONLY. IMPROPER USE OF
THE GROUNDING PLUG CAN RESULT IN A
RISK OF ELECTRICAL SHOCK.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OFF THE 3
RD
GROUNDING PRONG
Содержание Half Time Oven 2X
Страница 2: ......
