15
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Removing your MPXI-F level sensor from service should be done with care.
•
Ensure that all circuits are turned off and hazardous atmosphere around sensor head has been
cleared.
•
Remove housing cover and disconnect wires. Replace housing cover.
•
Disconnect conduit from sensor housing.
•
If the floats on your sensor fit through the mounting hole, carefully lift the entire sensor assembly out
of and away from the vessel.
•
If the floats on your sensor do not fit through the mounting hole, they will need to be removed from
the stem before the sensor can be removed. Be sure to drain the vessel being monitored to allow ac
-
cess to the floats and stem for removal.
•
Clean the stem and floats of any build up or debris and inspect for damage.
•
Store your sensor in a dry place, at a temperature between -40° F and 180° F.
• Removal Instructions
IMPORTANT
: Contact factory for shipping instructions prior to returning probe for any
reason.
