14
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Figure 2.2
UP
Taper
IMPORTANT
: Floats must be oriented
properly on the stem, or sensor readings will
be inaccurate and unreliable. Untapered floats
will have a sticker or etching indicating the top
of the float. Remove sticker prior to use.
NOTE
: Damage due to floats dropped on stem may not be be covered by warranty.
•
Connect approved electrical conduit to MPXI-F housing. Any fittings used must be UL/CSA Listed for
CSA installation.
• Remove the housing cover of your MPXI-F.
• Feed system wires into MPXI-F through conduit opening.
•
Connect wires to MPXI-F terminals. Use crimped ferrules on wires, if possible.
• Replace the housing cover.
•
For EMI protection, see installation instructions on drawing 9006113 (Installation Drawing For MPXI) on
page 37.
See System Wiring Diagrams (pages 8 - 9) for wiring examples.
• Electrical Installation
IMPORTANT:
WARNING -- A CONDUIT SEAL SHALL BE INSTALLED WITHIN 18 inches OF THE ENCLOSURE;
AVERTISSEMENT -- UN SCELLEMENT DOIT ÊTRE INSTALLÉ À MOINS DE 18 inches DU BOÎTIER.
