Apex Digital APXBASE, Руководство по установке

Страница: 4 / 14

3
4. Cut the wires
a. Cut the wires flush about 1/2" from where the jacket was stripped off the cable. Make
sure to leave enough that the ends of the wires are able to reach the pins of the
connectors. The cable needs to go inside the connector housing enough for the crimp
tab to come down on top of the jacket and hold it in place.
5. Insert wires into connector
a. Insert the wires into the connector. Make sure the connector is oriented properly, the
release tab should be facing down toward the ground. Ensure all wires are still in the
correct order after they are pushed all the way to the pins.
6. Crimp the connector
a. Insert your connector with the wire inside the 8P8C slot of your crimp tool. Give the
crimp tool a good squeeze to ensure it goes through the full range of motion and
creates a proper crimp. Pull your connector out of the crimp tool to show your finished
connector. Repeat all of these steps to crimp a connector on the other end of your
cable.
7. Verify connections
a. Verify the connections on the Cat 5 cable by using an Ethernet cable tester.