Apex Digital APXBASE, Руководство по установке

Страница: 5 / 14

4
Installing the Speaker and Microphone
The microphone and speaker must be wrapped in the foam boxes provided installed into a housing. A RF brand speaker post is recommended. Installing the
microphone and speaker improperly will void the system warranty.
1. Plug the Ethernet cable into the network port on the microphone.
2. Connect the microphone to the speaker using a Western Union splice and solder. Apply heat shrink or electrical tape over the solder joint.
a. The green and black wires on the microphone attach to the white and black wires on the speaker.
Western Union Splice
3. Place the microphone on the top shelf of the speaker post using the foam box provided.
4. Place the speaker on the bottom shelf of the speaker post using the foam box provided.
5. Connect the two-wire cable to the leads of the in-ground loop using the Western Union splice and solder. Apply heat shrink or electrical tape
over the solder joint.
Installing Loop Detector
Follow the instructions provided with the vehicle detector for installation and wiring to the loop.
Installing the Base Station
Choose the best location.
Normally the base station is centrally located and close to the order takers. Keep in mind that the location can affect the
performance and usability of the base station. If possible, follow these guidelines. The bottom of the base station should be at least
5ft from the floor.
• The base should be within 6ft of an electrical outlet.
• The base station should be away from any equipment that could cause liquid damage or heat up the system.
• The base station touch screen should be easily accessible to allow full functionality and ease of use.
Mounting the Base Station
Using the supplied wall mount with hardware, follow the instructions provided in it to install the mount to the wall and the base.