E n g l i s h
| 5
safety distances which are: 50 cm to the side and above the equipment and 70 cm to the rear part of the
oven.
Do not place the device near flammable materials or containers of flammable materials (such as walls,
furniture, screens, gas canisters) as this can create a fire hazard. If this is not possible, cover the flammable
parts with fireproof and heatproof material and check the fire hazard regulations.
0.1.3.
Preparing for installation
Remove the outer packaging (wooden or cardboard box) and dispose of it in compliance with the laws in
force in the country of installation.
REMOVING PROTECTIVE FILM ETC.
Remove all the protective film from the external and internal walls. (refer
to the photo on the side)
Remove all informative material from the inside, and take off all plastic
packaging.
STAND ADJUSTMENT
Do not use the appliance without feet.
The adjustable feet are already screwed to the underside of the oven.
If they are not used, this prevents air from cooling the electric parts and
outside of the oven which causes over-heating and damage to
components.
The oven will function correctly if placed level on a flat surface by adjusting the feet accordingly and using a
spirit level. Screw or unscrew them as necessary to adjust.
0.1.4.
Electrical connection
ATTENTION: Mains connection must be carried out by a qualified and authorised technician according to
national, international and local laws in the country where it is installed.
Before connecting the mains supply, ensure that the frequency (…..V)
and voltage (….Hz) meet the requirements indicated on the
Information Plate situated at the back of the appliance
.
The oven must be connected directly to the mains power supply and
must have an easily accessible switch upstream from it. It must be
installed to the system according to the national, international and
local laws in the country where it is installed. This switch must have
separate polarisation guaranteeing complete disconnection in accordance with the overvoltage III category.
Correct earthing is obligatory and the earth wire must not be disconnected by the protection switch.
ATTENTION: if the appliance does not have supports with wheels that facilitate movement, it is
recommended to execute the mains power supply connection first and then place it in its operating
position, being careful that the power supply cable is not damaged during handling operations. This
facilitates execution of the electrical connections in total safely. Place the cable in such a way that no point
exceeds 50°C room temperature.
CABLE CONNECTION
The oven must be connected to the electricity with a rubber cable such as H07RN-F.
ATTENTION: When connecting the power cable, arrange the different conductors so that the earth one
(yellow-green) is three cm longer than the other wires.
