20
PROBLEM 1: THE UNIT HAS NO POWER
1. Check if the unit is switched ON.
2. Check the fuse. Replace with the same type if fuse is blown.
3. Check the power cord and make sure there are no disconnections.
4. Verify that the unit is properly connected to the power source.
PROBLEM 2: TEMPERATURE DISPLAY IS ALWAYS ABOVE 500
o
C
Description:
Constant display of above 500
o
C temperature from the
panel then displays a blinking “OFF” on the panel after a few minutes.
SOLUTION:
The thermal sensor may be broken and needs to be replaced.
PROBLEM 3: ACTUAL AIR TEMPERATURE IS NOT INCREASING
Description:
Actual temperature reading is not increasing or decreasing
based on desired level. The panel will then display a blinking “OFF” on
panel.
SOLUTION:
The heating element may be broken and needs to be replaced.
PROBLEM 4: THE UNIT IS VIBRATING TOO MUCH
Check if the 4 screws that hold the pump in place are properly and tightly
connected. Unplug the system from the main power source before
opening the case to check the internal settings.
PROBLEM 5: THE UNIT IS VERY NOISY
SOLUTION:
Make sure the screw at the center of the base of the main
unit has been removed. This holds the pump in place during
transportation and needs to be removed before using the equipment.
BASIC TROUBLESHOOTING GUIDE
5
PACKAGE INCLUSION
Soldering Iron with
Smoke Absorber
30181X Filter Pads
(
6 pcs.
)
Power Cord
939 Vacuum
Suction Pen
2630B Soldering Iron Holder
with Solder Wire Stand
Hot Air Gun and
Hot Air Gun Holder
Air Nozzles
(1124, 1130,
1197
,
1010, 1313,
738 Main Station
Soldering Iron
Spare Heating Element
G001 IC Popper