6
SPECIFICATIONS
MAIN STATION
Power Input :
available in 110V / 220V
Station Dimensions:
188(w) x 126(h) x 250(d) mm
Weight:
6.3 Kg
SOLDERING IRON
Power Consumption:
45W
Temperature Range:
200°C 480°C
Heating Element:
Ceramic Heater
Output Voltage:
24V
HOT AIR GUN
Power Consumption:
550W
Temperature Range:
100°C 480°C
Heating Element
Metal Heating Core
Pump/Motor Type:
Diaphragm Pump
Air Capacity:
23 l /min (max)
19
●
Solder the other RED wire of heating element with YELLOW wire on
PCB.
●
Solder BLUE wire of heating element with BLUE wire on PCB.
●
Solder WHITE wire of heating element to with BLACK wire on PCB
The 5 pin Solder Iron socket can be tested to detect faults in the
hand piece:
Before plugging in the hand piece conduct the following test:
If any of the above mentioned combination registers a short review the
steps in replacing the heating element to ensure proper connections.
CARE and MAINTENANCE
Pins 4 & 2
∞
Pins 4 & 1
∞
Pins 5 & 1
∞
Pins 5 & 2
∞
Warning: Ensure none of the above mentioned conditions are
present before plugging in the hand piece. Failure to do so can
damage the internal circuitry of the unit.
Test the resistances of the following configurations:
If resistance test conforms to the above tables then the soldering iron
hand piece is deemed working and can be plugged in to the Soldering
Iron receptacle for usage, if problems after installation of new heating
element occurs review the previous steps to double check connections.
Note: resistance value of sensor(Pins4&5) may vary according to ambient
temperature
Pins 1 & 2
19 to 23
Ω
Pins 4 & 5
1.2 to 3
Ω
Pin 3 & solder tip
Below 2
Ω