Antunes JS-1000, Международное руководство пользователя

Страница: 11 / 18

P/N 1011512 Rev A 10/18 11
Figure 7. Properly Lubricated O-Ring Figure 8. Properly Seasoned Generator
Checking and Cleaning Water
Strainer
To ensure proper and consistent steam-
ing results, inspect the water pressure
regulator gauge and strainer cup regu-
larly. If the water pressure on the gauge
has dropped, visually check the clear
plastic strainer cup and clean out the ac-
cumulated debris as follows:
1. Shut off the water supply valve to
the unit. Unscrew the clear plastic
strainer cup and carefully remove the
mesh strainer screen.
2. At the sink, gently flush all of the
accumulated debris from the strainer
cup and mesh strainer screen. Be
especially careful not to damage the
mesh strainer screen.
3. Carefully place the mesh strainer
screen into its seat at the bottom of
the clear plastic cup and confirm that
the O-ring is properly seated in its
place before screwing the strainer
cup and top back together.
4. Purge the air out of the strainer tub-
ing by disconnecting the male quick
disconnect fitting from the equipment
and, over a bucket, pushing its valve
core in until there is a good water
flow.
Quarterly Cleaning
This unit utilizes an open steam genera-
tor. When introduced, water immediately
vaporizes creating a burst of steam,
leaving behind any minerals that had pre-
viously been dissolved. Though a small
amount of minerals are necessary for
proper operation, excessive amounts will
cause poor steaming and may perma-
nently damage the generator.
1. Turn the unit off and allow it to cool
before proceeding.
2. Put on heat resistant gloves and
open the top cover.
3. Loosen both Lock Knobs (see Figure
6). This allows the Generator Mani-
fold to be opened.
4. Use a flat blade screw driver to
gently pry up the Generator Manifold
and remove it.
5. Inspect the Generator Manifold and
Generator (Figure 5). If mineral
deposits have formed, place a flat
blade screwdriver into openings. Use
a twisting motion to scrape openings
clean.
NOTICE: If the mineral deposits come
off in “flakes” or in layers,
build-up is excessive.
6. Use an abrasive cleaning brush and
small scraper to remove deposits
from the generator surface and Gen-
erator Manifold.
7. Pour food safe delimer solution
or vinegar (not supplied) onto the
generator surface and allow to soak
for one hour.
NOTICE: Be sure to follow the delimer
manufacturer’s directions for
proper mixture and use.
8. Remove the delimer solution from
the generator and rinse with clear
water to remove traces of delimer.
9. Season the Generator if required.
See the notes below for seasoning
instructions.
NOTICE: To ensure proper steaming
characteristics some mineral
deposits must be present on
generator casting. If during
cleaning, the casting does
become free of mineral de-
posits, add ordinary tap water
(non reverse osmosis or ionic
filter system) to casting and
allow to boil off.
NOTICE: Seasoning mixture consists
of 1 tablespoon baking soda,
and 1 cup water. This is nor-
mally 1 box of baking soda to
1 gallon of water. The mixture
should look similar to milk.
Pour 1/4” deep of seasoning
mixture into a cold generator.
Make sure the top cover is
closed. Turn the unit on. After
mixture is converted to steam,
the remaining loose powder
is removed and generator
cleaned.
10. Wipe the exterior of the unit and
the inner part of the top cover with
a clean, sanitized towel. Allow to air
dry.
11. Re-lubricate O Ring.
12. Re-install Generator Manifold and
tighten Lock Knobs.