Anthro Elevate II Adjusta, Руководство по сборке

Страница: 5 / 8

Elevate II Adjusta Assembly Instructions
5
STEP 3 - INSTALL THE CROSS PAN
ƒ
Align the Cross Pan with the Leg Assemblies so the pair of flanges
on the pan line up with the pre-drilled holes on the table. Attach
the back of the pan to the top with four 3/4" MDF Screws
(325-5575-00) and attach the front of the pan to the top with
three 3/4" MDF Screws.
ƒ
Attach the pan to each leg housing with two M6x14 Button-head Screw
(325-5503-00) using the Anthro driver.
ƒ
Tighten all fasteners.
STEP 4 - INSTALL CONTROL BOX
ƒ
Align the Control Box with the Cable Tray so the ports face up and the holes
on the Control Box line up with the holes on the Cable Tray. The Control Box
installs at the center of the tray on the 48w table. The 60w table comes with
three installation points (left, center, and right). Attach the box to the tray
with four 1/2" Button-head Screws and four Nylock Nuts using your own 3/8"
socket (or the 3-way wrench provided) and the smallest hex key (1/8") in your
kit.
1/2”Button-hd Screw
325-5193-00
Nylock Nuts
325-5186-00
Attaching the Control Box to the Cable Tray
of a shallow 48" wide table.
1/2” Flat-head Screw
325-5193-00
Nylock Nuts
325-5186-00
M6-10 Button-head Screw
325-5503-00
3/4" Button Hd PB Screw
325-5575-00
STEP 5 - INSTALL CABLE TRAY
ƒ
Align the Cable Tray with the back of the table so the holes on the threaded posts on the cross pan line up with the holes
on the cable tray. Attach the tray to the pan with three Nylock Nuts using your own 3/8" socket or the 3-way wrench
provided. (The plastic end of the nut faces up.)
ƒ
Connect a 1-meter Control Box Cable to each leg cable, then plug each into a port on the Control Box through the
opening in the support pan. Feed extra cable length through an opening in the support pan so it's organized in the Cable
Tray.
ƒ
Plug the Power Cord into the Control Box.
ƒ
Use the provided cable clips to route and organize cords. Install one cable clip
next to the Leg Gusset for the Keypad Cord (Installed in Step 8). Install the
other clip next to the Cross Pan for the Control Box Cables.