This command affects the volume by decrementing the DB so you will want to configure the amplifier to
display DB.
Z2MuteON
[digital]
The Zone2 Mute ON join is used to activate volume muting for the zone 2. The command gets sent on the
rising edge of this join, the trailing edge has no effect. The current state is reflected in the Z2Mute_FB
output signal.
Z2MuteOFF
[digital]
The Zone2 Mute OFF join is used to deactivate volume muting for the zone 2. The command gets sent on
the rising edge of this join, the trailing edge has no effect. The current state is reflected in the Z2Mute_FB
output signal.
Z2MuteToggle
[digital]
The Zone2 Mute toggle is be used to change the mute state for the zone 2 from its current state to the
opposite state on the rising edge of this signal, the trailing edge has no effect. The current state is reflected
in the Z2Mute_FB output signal.
Analog Inputs
Source
[analog]
The Source input is used to set the source for the main zone. The number supplied matches the input
programmed into the Anthem. The name of the source is available from the Input Name serial joins and the
number of inputs is available from the TotalInputs analog output. This can be used directly or attached to a
list smart object.
Volume
[analog]
The volume join is used to set the main zone volume, in percentage. The value accepted is the Crestron 0 -
100% (0 - 65535), so no scaling is required.
Z2Source
[analog]
The Zone2 Source input is used to set the source for the zone 2. The number supplied matches the input
programmed into the Anthem. The name of the source is available from the Input Name serial joins and the
number of inputs is available from the TotalInputs analog output. This can be used directly or attached to a
list smart object.
Z2Volume
[analog]
The Zone2 volume join is used to set the zone 2 volume, in percentage. The value accepted is the Crestron 0
- 100% (0 - 65535), so no scaling is required.
Page 13
