9
LiION-BATTERIES
LiIo CHARGE
Push the button “BATT TYPE” until the display shows “LiIo”. Now use the “INC” or “DEC” button to get to “CHARGE” and then push “ENTER”
to confirm. After your confirmation the display will change to the capacity “C”. Now please set the capacity of your battery with the buttons
“INC” or “DEC” from 100 mAh to 5000 mAh and confirm with “ENTER”. The charge current is automatically set to 1C. The display changes to
the no. of cells / cell voltage which can be set with the “INC” or “DEC” buttons from 1 cell = 3.6Vp; 2 cells = 7.2Vp; 3 cells = 10.8Vp; 4 cells =
14.4Vp to 5 cells = 18.0Vp. The parameters shown on the display are set and stop flashing if no push button is pressed for 3 seconds. To start
charging, now push the “ENTER / START / STOP” button for 2 seconds. The display shows “BATTERY CHECK WAIT PLEASE“. After a short check of
all parameters the display shows the battery type “LI”, the charge mode “CHG”, the charge current e.g.: “+3.00A” (if the battery capacity is set
to 3000mAh) and the actual measured battery voltage “V”. The clock starts running in seconds and the display shows also the charged capacity.
When the charging is finished you will get an audible signal. The display shows the capacity charged into the battery.
Adjustments and the associated display you can be seen in the following chart:
Liio CHARGE
C=3000mAh 10.8Vp
Liio CHARGE
C=3000mAh 10.8Vp
Liio CHARGE
C=3000mAh 10.8Vp
Battery check
Wait please...
CHG 0:00 00000
LI + 3.00A 10.75V
#"555:1&
&/5&3
%&$
*/$
&/5&3
45"35
%&$
*/$
1_manual_xbase_07-01.indd 9
1_manual_xbase_07-01.indd 9
11.01.2007 16:43:52 Uhr
11.01.2007 16:43:52 Uhr
Prozessfarbe Schwarz
Prozessfarbe Schwarz
