Anslut 010415, Руководство по эксплуатации

Страница: 10 / 11

EN
10
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output Max 50 W
Socket GU10
Protection rating
IP44
Ambient temperature -25 to +50°C
INSTALLATION
NOTE:
• Switch off the power supply before
installation.
• The light is for wall mounting.
1. Switch off the power supply.
2. Pull the power supply wires through the
safety ring in the base of the product.
3. Insert the wires in the supplied sleeves.
Make sure the sleeves completely cover
the wires to the bulb socket, from the
safety ring to the safety plate on the
socket.
4. Correctly connect all the wires.
5. Mount the base in the required place with
expander screws.
6. Insert a light source with the maximum
output specified for the product.
7. Fit the glass cover and the guard on the
base with the screws.
FIG. 1
SAFETY INSTRUCTIONS
• Only intended for outdoor use.
• The electrical installation must comply
with local regulations. Consult an
authorised electrician if in doubt.
• Always follow the electrical specifications
on the product labelling.
• Always disconnect the power supply before
installation, connection and service.
• Never modify the product, this could result
in serious personal injury and/or material
damage, and will invalidate the warranty.
• The product must be connected to an
earthed power supply on installation.
• Do not use the product without the glass
cover.
• The product gets very hot when it is
switched on. Do not touch the product
with bare hands.
• Switch off and allow the product to cool
before replacing the light source.
ELECTRICAL SAFETY
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.