Ankom TDF28, Процедура обслуживания

Страница: 9 / 10

In-Line Heater Replacement
(TDF28/28.1)
TDF
ANKOM Technology ● 2052 O’Neil Road ● Email: service@ankom.com ● Phone: 315-986-8090 ● Fax: 315-986-8091
Service procedure
TS018
Rev. B
6/04/2018
Page 9 of 10
34. Tighten the screw with a flathead
screwdriver to secure the wires in place.
Gently tug on the wire to ensure it is
secure.
35. Secure the blue cable and both In-Line
Heater conductors together with a cable
<e. Carefully cut off excess from cable
<e without damaging any insula<on.
36. Place a cable <e around the black In-Line
Heater cable and the gray Pressure
Sensor cable. Carefully cut off excess
from the cable <e without damaging any
insula<on.
NEW OLD
T1- L1-
33. Insert the remaining In-Line Heater
conductor into the HR wire connector
labeled “T1”, sliding the exposed part of
the conductor underneath the metal
tab.
33.
IMPORTANT:
The In-Line Heater
conductor should always go in the “T1”
spot, however, There are 2 models of
the Heater Relay. On the OLD model,
the “T1” spot is located on the LEFT. The
NEW model has the “T1” spot on the
RIGHT. The pictures in steps 34 and 35
show the NEW model of the Heater
Relay.