Anita GARUDAN GPS/G-1507, Руководство пользователя

Страница: 25 / 28

ANITA ©
GPS/G serie 25
8)
Trouble shooting
No. trouble cause remedy
1
Machine starts
and runs
abnormally
The fuse of power or circuit is
short-cut Make sure if the fuse is short-cut
of the main motor driver in
monitoring box
The feed bracket X or Y is
beyond its limit Move the feed bracket to its
normal position(within the
restrictive range)
3
state of hook
thread
The threading is wrong Replace the needle
Installation of the needle is not
right.( the height and direction of
the needle) Re-install the needle
The needle is damaged (bent,
needle hole becomes coarse,
needle point worn or deformed) Replace the needle
The tension between needle
thread and bobbin thread is too
large Adjust the tension
The tension of thread take-up
spring is too large and the motion
amount is too big
Adjust the tension and the motion
amount
The thread adjusting hole of the
spring on bobbin case is with
fissure Replace the spring on bobbin
case
4
crochet hook
The needle is damaged(bent,
needle hole becomes coarse,
needle point worn or deformed) Replace the needle
The installation of the needle is
not in line with the requirements Replace with the needle of
correct size
Friction between the needle and
bobbin Adjust the space between the
needle and the bobbin
5
Trimming
error occurs.
The cross tension between the
moveable knife and the fixed
knife is loose Adjust the tension of fixed knife
The blades of the movable knife
and the fixed knife are worn. Replace the cutter
The position of the trimming cam
is not proper Adjust the trimming cam.
6
Thread skips
or falls off the
needle eye at
starting
The needle is bent Replace the needle
The thread is not conformed with
the needle size Replace the needle
The installation of needle is not
proper Re-install the needle
The needle is not in harmony
with the motion of bobbin Re-adjust it
wider distance between need slot
and need piece Re-adjust it
www.garudan.cz