ANITA ©
GPS/G serie
11
2. Needle installing
Loosen the set screws on needle holder,
fully insert the needle end into the needle
socket in needle holder while keeping the
needle slot facing front, then tighten it
with the screws.
Fig. 6
3. Threading
Optimize the thread take-up lever, lead the thread
as the figure shows. When lead the thread for
heavy material through the needle holder guide, do
as the small figure shows.
4. Threading bobbin thread
A. (28)
Put Bobbin into Bobbin Case as the figure shows.
[Notice] Viewing from the back of shuttle hook,
the shuttle rotates in counterclockwise.
B. Bobbin thread is led through the hook gap and
then tied on Hole
C. The remain of bobbin thread end should be kept
about 25mm outside Hole.
Needle set screw
Needle
Fig. 7
Fig. 8
www.garudan.cz
