ANITA ©
GPS/G serie
20
9.
Adjust the fittings of wiper mechanism
A) The way of adjust wiper mechanism position
a) When the distance between needle tine
and needle board is 19.5mm , loose screw
(1) and (2) in wiper mechanism ‘eddy axis
b) After pressing the wiper drive brace (3) of
wiper mechanism, adjust wiper axis (4),
make the distance between wiper thread
hook and needle be 10mm.
c) Please screw down (1) of circumrotate
axis and brace screw (2).
d) Loose the screw (5) in wiper thread hook,
let the distance between wiper thread hook
and needle be 1mm, and then fix screw.
Fig. 29
B)switch of wiper mechanism
Press switch (A) “-” position to start wiper
mechanism, press switch (A) “Opposition
to shut mechanism.
Fig. 30
10. Adjust about cut-thread parts
A. Adjust the position of cut-thread cam.
Adjust the distance of up-axis and cut-thread cam to 2.5mm, and adjust cut-thread cam mark
consistent with up-axis mark
，
and then fix screw (1).
[Notice] If the
position of cut-
thread cam is
not nicety, may
be cut-thread
could not be
achieved or
machine could
be locked.
Fig. 31
www.garudan.cz
