ANITA ©
GPS/G serie
14
7) MECHANIC MAINTENANCE
1. Adjusting needle bar
Loosen Screw at the lowest position of the
needle holder, adjust the needle upper line to
be in accordance with the needle holder
socket line as the figure shows. Then tighten
Screw.
Fig.15
2. Adjusting needle and shuttle
A. At the lowest position of the needle holder,
adjust the needle upper line to be accordant with
the needle holder socket line as the figure shows.
Fig.16
B. Slide open Needle Plate, take out Shuttle Ring from Shuttle.
C. Keeping Needle Center Piece(A) in line with the screw tip of shuttle
D. Loosen Screw, rightward eddy needle adjust axis let the distance is 0.05-0.1mm between
need piece (A) and shuttle, and than adjust shuttle direction .
E. After adjust screw eddy direction, let needle and shuttle distance is 7.5mm, screw of
[Notice]
For safety, fully tighten the screw after adjusting the big shuttle.
above
under
www.garudan.cz
