Angel Water PurAzone A03, Руководство пользователя

Страница: 6 / 34

5
Instillation Instructions
(all electrical & plumbing should be done in accordance to all local codes)
Your new Iron Blaster™
allows for simple installation and
start
up. Installation diagrams are provided to assist you.
Use of these diagrams and the following procedures will
ensure that
the system is properly installed.
Follow all state and local plumbing and electrical codes!
• Do not use vaseline, oils, other hydrocarbon lubricants
or
spray silicone anywhere. A silicon lubricant may be used
on black o
‑
rings but is not necessary.
avoid any
type
of lubricants, including silicone, on red or clear lip
seals.
• Do not use pipe dope or other sealants on threads.
Only teflon tape may be used on threads. Teflon
tape is not
necessary on the nut connection or caps because of radial
o
‑
ring seals.
• The pipe size for the drain line should be a minimum
of 3/4”. Backwash flow rates in excess of 10 gpm or
length in excess of 20’ require 1” drain line.
1. Place the filter where you want to install it, making sure
it is on a clean, level and firm base.
2. Do all necessary plumbing (Install check valve on inlet
to filter, inlet to inlet, outlet to outlet and drain line to
drain). The control valve, fittings and/or bypass are
designed to accommodate minor plumbing
misalignments but are not designed to support the weight
of a system or the plumbing.
3. When assembling the installation fitting package (inlet
and outlet), connect the fitting to the plumbing system first
and then attach the nut, split ring and o
‑
ring. Heat from
solder
-
ing or solvent cements may damage the nut,
split ring or o
‑
ring. Solder joints should be cool and
solvent cements should be set before installing the nut,
split ring and o
‑
ring.
Avoid getting primer and solvent cement on any part of
the o
‑
rings, split rings, bypass valve or control valve.
4. a jumper ground wire should be installed between the
inlet and outlet pipe whenever the metallic continuity
of a water distribution piping system is interrupted.
Install grounding strap on metal pipes.
5. The drain connection may be made using either 5/8” poly
-
tube with nut & insert (see page 23, figure 17) or a
3/4”
female adapter. If soldering, joints near the drain must be
done prior to connecting the drain line flow control fitting.
Leave at least 6” between the drain line control fitting and
solder joints when soldering pipes that are connected on
the drain line control fitting. Failure to do this could cause
interior damage to the drain line flow control fitting.
6. When installing a filter system it is common to provide filtered
water to some fixtures such as the kitchen cold faucet. This
is typically done as a matter of personal preference. In rare
occasions it has been noted that the customer may experi
-
enc some air in the filtered water line on the morning after
regeneration. It has proven to be beneficial to plumb the
line for filtered
‑
only water fixture in a downward direction
before the inlet to the softener (12 inches recommended),
then make a reverse turn and go upward toward the fixture.
Understanding that air always rises to the highest point in
a water system.
When installing an Iron Blaster™ Filter system it is common to provide filtered only water to some fixtures such as the kitchen cold
faucet. This is typically done as a matter of personal preference. On rare occasions, the customer may experience some air in the
filtered water line the morning after regeneration. It has proven beneficial to plumb the line for the filtered only water fixture in a
downward direction from the inlet of the softener (12 inches recommended), then make a reverse turn and go upward toward the
fixture. Any accumulated air always rises to the highest point in a water system and cannot naturally flow downward.