Anest Iwata MSA-200, Инструкция по эксплуатации, Страница: 13 / 18

－１３ －
3-3 Fitting or removing nozzle tip
(each tip is optional except attached NT-2004CMU).
※
Refer to 4 on page 14 and prepare nozzle tip separately.
WARNING
Be sure to stop pump, reduce air pressure (operating air, atomizing air) and fluid
pressure down to 0 pressure before you fit or remove nozzle tip.
3-4 Painting job
WARNING During painting, be sure to wear protective cover such as glasses, mask or gloves to
avoid serious injury caused by paint or solvent which might enter your eyes or you
might inhale.
H I N T !
•As fluid pressure and air pressure increase, paint mist becomes finer and finishing
becomes better. But on the other hand, high pressure can be dangerous, precipitate
corrosion of equipment and nozzle tip, increase spray mist and decrease transfer
efficiency. Adjust pressure to the lowest level possible (fluid pressure 4.9MPa, atomizing
air pressure 0.15MPa) as long as the finish is satisfactory.
•Adjust spray distance to nearest level possible as long as the finish is satisfactory in order
to reduce spray mist and increase transfer efficiency.
3-5 Adjust spray pattern and delete tails
3-6 Solve clogging of nozzle tip
when removing
pin
when fitting
nozzle tip
air cap set
Loosen air cap
cover and remove
nozzle tip
groove
inside of air cap
rear side of
nozzle tip
Fit pin to inner groove
of air cap and tighten
air cap cover.
pin
T
ails appear according to
fluid viscosity and property
when they appear increase
atomizing air pressure a bit
Pattern size and fluctuation
differ according to nozzle tip.
to get small
pattern loosen
to get flat
pattern tighten
till it stops
Delete tails
Adjust spray pattern
atomizing air pres high
tail
do so after removing nozzle tip from air cap
When using attached cleaning needle
When blowing with air
cleaning needle
air