Anderson WRAPTOR, Руководство оператора

Страница: 35 / 70

33
10 Troubleshooting
Breakdown?!?
You machine is functioning poorly or not at all?!? Before calling a technician, examine your
machine and consult the table below to find a solution. If you are still not able to solve the
problem yourself, ask for help from the customer service department of your agricultural
dealer.
Troubleshooting Table
Problems Possible Causes Solutions
The fuel valve is closed.
Open the fuel valve and start
again.
The gas tank is empty.
Put fuel in the tank and start
again.
The low engine oil sensor of the
Honda engine is activated.
Add oil to the engine and start
again.
The spark plug is clogged or
defective
Clean the spark plug or change it.
Remove the spark plug, dry it out,
dry out the cylinder by activating
the starter crank. Put back the
spark plug and start again.
The engine is flooded because the
fuel valve was not closed during
transportation.
Change the oil.
1. The engine does not
start.
Too much oil in the oil pan. Adjust oil level.
Tighten the wheel spring.
Check tire air pressure and adjust
if necessary.
The drive wheel slides on the hoop.
Change the tire if it is worn out.
Check oil level. Check for leaks.
2. The hoop does not
turn.
The drive wheel does not turn.
Check the condition of the wheel
motor and change it if necessary.
3. The hoop lose speed. Lack of hydraulic oil or oil pressure.
Check oil level. Check for leaks.
Adjust as needed.
Check that the plastic film roll is
installed as indicated in the
diagram.
The film is not tight enough.
Check that stretcher and spring
parts are in good condition.
Debris have become wrapped
around the rolls or in the stretchers.
Remove the debris and check the
general condition of the stretchers.
The aluminum rollers are dirty. Clean them with penetrating oil.
The rubber roller is damaged. Replace the rubber roller.
4. The plastic film
breaks at normal
temperatures.
The spikes have become rough. Gently sand the spikes.