Anderson WRAPTOR, Руководство оператора

Страница: 22 / 70

20
film stretcher. Attach the end of the plastic film to the plastic film holder, which is just above
the control levers.
Figure 6.3 Installing the plastic film roll
Installing the 2
nd
Plastic Film Roll
Release the brake of the hoop wheel, turn the hoop 180 degrees, and reengage the brake.
Repeat the preceding installation instructions. Put the screen back in place and do not forget to
release the hoop brake before starting the engine.
Leaving the plastic rolls in the sun for an extended period of time before installation can cause
the film to become soft. The film can then be stretched too easily during wrapping and will be
more like to tear or break.
Bring your bale wrapper to your chosen location. Remove the draw bar from the machine and
store it in the support on the front right side of the machine.
Adjusting the Hoop’s Drive Wheel
If the hoop slips or stops, you can increase the tension of the spring that holds the wheel in
place. All you have to do is tighten the nut on the threaded rod, located above the spring to the
left of the wheel (Figure 6.4).