Anderson WRAPTOR, Руководство оператора

Страница: 21 / 70

19
6 Wrapping Settings
Installing the 1
st
Plastic Film Roll
First, open the protective screen on the right side of the hoop. (The screen on the left side
always remains attached to the machine. In case of breakage, you can open it using the
appropriate tools.) Pull on the latch at the top left corner of the screen and slide it forward.
If one of the two film dispensers is not at a good height for your, manually turn the large hoop
upwards to bring the dispenser within reach.
To prevent the hoop from turning during installation, engage the hoop brake pedal, located to
the left of the drive wheel (Figure 6.1).
Figure 6.1 Brake pedal
Remove the pin from the front roll support, slide the support forward, and, if applicable,
remove the empty spool. Install the new roll so that the plastic film unwinds as indicated, push
the support back in place, and put back the pin (Figure 6.2).
Figure 6.2 Roll support and stretcher
Next, follow the diagram (the same diagram as is on the machine) (Figure 6.3) to thread the
film, first behind the black rubber free roller, then through the 2 aluminum rollers of the plastic