Anderson RB-400, Руководство оператора

Страница: 17 / 52

15
Start-Up
We assume that you have started up your tractor and connected the hydraulic system (the
recommended flow rate is 8 GPM at 2000 PSI), or that you have started the gasoline engine of
the optional hydraulic unit. We also assume that your bale counter has been properly
programmed.
First Bale
Take a round bale and place it in the center of the feed rollers, preferably on the side opposite
the plastic film stretcher. The bale will turn counterclockwise. Attach the edge of the plastic film
to the ties or net of the bale. Pull the wrapping lever (1) (Figure 5.2). Wrapping will begin.
When you approach the maximum number of rotations, the screen of the counter will blink and
you will hear 3 beeps. Stop wrapping when the table is properly aligned (the axis of the bale
must be parallel to the axis of the axle).
Unloading and Second Bale
Take the time to properly align your table relative to the unloading platform (optional) and pull
its lever (2) (Figure 5.2) to tilt the table. During this operation, the plastic film cutter will be
engaged and will cut the plastic film and hold onto one of the cut ends. Next, lower the table
again and place a new bale on the feed rollers. The first bale can be retrieved from the ground.
WARNING !
Tilt the table when it is badly aligned may cause damage to your machine.
End Bale Wrapping
If you have the hydraulic unit, shut off the fuel valve to prevent the gasoline from seeping into
the engine oil. Once your batch of bales has been stored, take the time to check the air
tightness of the plastic film on your bales. As necessary, seal the air leaks with tape so that
fermentation will begin rapidly. Use the tape recommended by your plastic film supplier.
5.4 Adjusting the Sensors
Place the 2 parts of the sensor at position 1 so that they face each other, turning the table by
pulling the control valve lever, and adjust the distance between them to 1/8 inch (2.5 mm)
(Figure 5.3).