Anderson RB-400, Руководство оператора

Страница: 16 / 52

14
Operation Menu of the IG-C3 Bale Counter
-
If you press the ER. COUNT. DAY. button, the screen will ask you to confirm NO - . or YES
+ whether you really want to erase the daily counter.
-
Similarly, the . ER. COUNT. REV. button allows you to reset the revolution counter to zero
during a test or during a missed cycle. You must confirm the operation.
-
The ON / OFF . button on the right allows you to turn on or off the illumination of the screen
during operation. The internal battery consumes 10 times less energy when the screen is
turned off. The illumination of the screen automatically turns off after 20 seconds if the
counter is not being used.
-
To shut down the module and close the operation MENU, press the . ON/OFF button on the
left. The data will be saved. When not being used, the bale counter will go into energy saver
mode after 5 minutes.
Advanced Menu of the IG-C3 Bale Counter
To reach this menu, hold down the . ADJUST.SELECT . button for 3 seconds.
-
Program 1 : The 1
st
program allows you to: Enter the number of revolutions, MAX: 00 per
bale by pushing the . - / + . buttons. The minimum number is 2 and the maximum is 80.
Holding down one of the . - / + . buttons for 3 seconds will cause the number to change
faster. We recommend 18 revolutions with 30-inch plastic rolls so as to obtain 4 layers on all
surfaces of the bale. Certain users will want more layers or fewer layers.
-
Program 2 : Pushing the ADJUST. SELECT button again will take you to program 2, which
allows you to modify # bales Day: 000 (in the same manner as for program 1). If you
press the
. - / + buttons simultaneously, the number will be reset to zero.
-
Program 3 : Pushing the ADJUST.SELECT button a third time will take you to program 3,
which allows you to: modify # bales Year: 0000 .
-
Program 4: Choose your language with the . - / + buttons: French or English.
You have finished programming the bale counter and the ADJUST.SELECT menu will bring
you back to the operation menu.
5.3 Start and End Wrapping
Levers
# FONCTION
1 Wrapping lever
2 Tilt the table
Figure 5.2
Levers
1
2