Anatol VOLT, Руководство оператора

Страница: 56 / 68

3. Select the job you want to load from the Job Name list.
When the job is highlighted, it will change color and the Load Job and Delete Job
button become active. If there are a lot of items in the list, see Searching in the Lists
Window.
4. Press the Load Job button.
The Job List window closes and the Saved window appears on the Machine
Configuration screen.
5. Check that print heads and flashes are in the correct positions.
6. If the print head and flash numbers are correct, press the OK button. When you press
OK, the Saved Job Setup window closed. The progress of loading parameters will appear
on the screen.
If you want to cancel loading these parameters, press the Cancel button. When you
click the Cancel button, the Saved Job Setup window closes without change to the
current machine parameters.
7. Wait until all parameters are loaded – the progress bar fills and the Wait button will
change to Success.
8. You can close the download progress window by clicking on the button that is located in
this window or by clicking anywhere outside the area of the open windows.
If you have a problem, see Something went wrong when you save the parameters
Check Parameters
Below is a situation that may occur when loading machine parameters.
Situation: The screen displays showing the parameters are loading, but the progress
bar is empty or only partially complete.
Solution: If the message “RS232 timeout” is displayed, then Load Job Parameters has
failed. The most likely cause is failed communication between the machine driver and
the monitor. In that case, turn the machine off and turn it back on again, and then try
to load the job again.
2.8 Saving Current Job Settings and Loading Saved Work
anatol.com 56