ADM, HBOT & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-14
June 2017
Page 12 of 43
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
4.4
Charging the Analox
Aspida
WARNING:
The following safety warnings should be observed before attempting to charge
the Analox
Aspida
:
The Analox
Aspida
should only be charged when the NiMH batteries supplied with the
product are fitted. Attempting to recharge non-rechargeable alkaline batteries will in most
cases result in an aborted charge, and this will be indicated by a flashing
icon on the
display. However, connecting the mains charger whilst using alkaline batteries is not
recommended and may result in damage to the device.
The Analox
Aspida
may be used with standard rechargeable AA type batteries which have
been charged using a third-party charging device. However, only NiMH batteries provided by
Analox should be used when attempting to charge batteries within the device using the mains
charger.
Do NOT attempt to charge the batteries in the HBOT Aspida while the device is inside the
hyperbaric chamber.
Do not attempt to charge the device using a mains charger other than the one supplied with
the device. Use of an incorrect mains charger may damage the device and invalidate the
warranty.
The battery cover should always be securely fitted before performing a charge.
•
With the mains charger disconnected from the wall outlet, insert the power jack into the
socket on the rear of the
Aspida
device.
•
Insert the mains charger into the wall outlet.
•
Switch on the mains at the wall outlet.
NOTE:
The unit can be charged whilst switched on or switched off.
