ADM, HBOT & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-14
June 2017
Page 10 of 43
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
Make sure that the pipework supplied with the ADM Aspida has been connected to your gas line and
the supplied 9V PSU’s DC jack is connected to the rear of the unit.
Remove the screws and align the ADM Aspida front panel mounting holes up with the captive nuts,
then re-insert the M5 x 25mm Pozi Pan screws through and tighten.
The diagram below shows the exploded view of the ADM installation.
4.2
Gaining access to the ADM Aspida
To gain access to the ADM Aspida for either USB connection or sensor change the following steps
should be followed.
Firstly remove the ADM Aspida from the instrument panel by removing the four M5 x 25mm Pozi Pan
screws.
Turning the ADM Aspida over, remove the two left most screws and washers from the tie bases.
