NATIX™
PAGE 26
Chapter 5 : USING FRAME STORE AND LOGO INSERTION
5-1. USING LOGO INSERTION WITH THE REMOTE CONTROL SOFTWARE
This function allows storing up to 8 logos in order to incrust them into the displayed image (up to 2 logos at a same time).
IMPORTANT
: The output format used when displaying logo should be the same that the output format used during the
logo storing.
5-1-1. HOW TO STORE A LOGO
c
Click on the
Logo & Frame out 1
tab to record the logo from the output 1 or click on the
Logo & Frame out 2
tab
to record the logo from the output 2.
d
Then click on the
Record logo
tab: the device displays a white rectangle corresponding to the logo selection area
onto the output. Then adjust the position and size of the logo area with the position functions.
NOTE:
The logo area is limited to an eighth (1/8) of the displayed area.
e
If necessary, adjust the
luma key
level. This function allows to "erase" the darkest portions of the logo selection
area in order to make special logo contour. Otherwise set the
luma key
level to zero.
NOTE:
You can change the color of the "erased portions" of the logo with the
background color
function.
f
Click on
STORE
to store the logo into a memory. The memorization of the logo starts and will take about few
seconds.
NOTE:
Renew the steps
c
to
f
to store another logos (up to 8).
5-1-2. HOW TO ASSIGN A LOGO
NOTE:
You can assign the stored logos to one or many of the 8 inputs (up to 2 logos by inputs).
g
In the
assignment
table, assign for each input the needed logos.
NOTE:
To remove a logo of an input, select
none
in the corresponding window.
5-1-3. HOW TO DISPLAY OFF or ON A LOGO
h
To display OFF or ON the assigned logos of an input, click on the
display
button of the corresponding input to
change the status (ON or OFF).
NOTE:
When displaying ON or OFF a logo, this one appears/disappears with a fade effect. You can adjust the
duration of the fade effect with the
Frame fade duration
function of the
Control
menu.
5-1-4. HOW TO ADJUST THE LOGO POSITION
i
Select the input of the logo to adjust (with the INPUT SELECTION buttons).
j
Click on the logo to adjust, then click on the
use
tab of the
Logo & frame
window. Then adjust the logo position
with the
H &V position
functions.
NOTE:
When you are using 2 logos by input, make sure to not superpose a logo onto an other one. In case of
superposition, the logo areas will appear colored.
Figure 21
c
d
f
g
e
Содержание NATIX NTX8022A
Страница 1: ...ANALOG WAY NATIX EDITION 12 04 MODELS NTX8022A NTX8022A D User s Manual...
Страница 2: ......