Evaluation Board User Guide
ADXRS450 - UG
Rev. 0 | Page 3 of 17
INERTIAL SENSOR EVALUATION SYSTEM SETUP
DOWNLOAD ALL FILES TO PC
Before proceeding with the installation routine, it is important
to first download all files included on the ADXRS450
installation CD-ROM to a local folder on the host PC. Browse
to a destination directory on the host PC and right click in
order to select New -> Folder. Name this folder, and then copy
the CD-ROM files into this new location. The user is now
ready to begin the installation routine.
ISEB HARDWARE SETUP
Before connecting the ISEB hardware to the PC via the included
USB cable, drivers need to be installed so that the PC will
properly recognize the ISEB main board. The USB drivers for
the ISEB are available in the /
ISEB_USB
/ folder on the
packaged CD.
Installing the USB Drivers for the ISEB
To install the USB drivers, follow these steps.
1.
Execute the ADI_ISEB_USB_Drivers.exe file located in
/
ISEB_USB
/.
2.
Follow the on-screen instructions to install the drivers.
3.
Click Continue Anyway when prompted that the drivers
are not tested.
Once the above steps have been completed, the user can now
connect the ISEB main board to the computer via the included
USB cable. Once connected, if the previously installed drivers
are not automatically associated with the device, then the user
may need to select the drivers manually. Refer to the following
steps if this action is required.
1.
Connect the USB A to Mini-B cable to the PC and then to
the ISEB. The satellite board does not need to be connected
for this step. New hardware is detected upon completion of
this step.
2.
If prompted to install drivers again, click
Install from a list
or specific location (Advanced)
, see Figure 2, then click
Next.
Figure 2. Found New Hardware Prompt
3.
Select
Don’t search. I will choose the driver to install
(see
Figure 3) and click Next
4.
Select
ADI Inertial Sensor Evaluation System
from the
model list (see Figure 4) and click Next to complete the
process
The ISEB should be detected automatically in the
Device
Manager
as the
ADI Inertial Sensor Evaluation System
under
the
Ports (COM & LPT)
selection. It is recommended to open
the
Device Manager
to verify hardware detection and to record the
communication port associated with the ISEB for use in the GUI.
Figure 3. Selection of the Driver to Install
Figure 4. Selection of the ADI Inertial Sensor Evaluation System Drivers
08119-
002
08119-
003
08119-
004
