Installation Tasks
1-6
ADSP-21262 EZ-KIT Lite Evaluation System Manual
3. Plug the provided power supply into
J7
on the EZ-KIT Lite board.
Visually verify that the green power LED (
LED10
) is on. Also verify
that the two red reset LEDs (
LED9
and
LED12
) go on for a moment
and then go off, and, finally,
LED8–1
are continually blinking.
4. Connect one end of the USB cable to an available full speed USB
port on your PC and the other end to
P4
on the ADSP-21262
EZ-KIT Lite board.
Figure 1-1. EZ-KIT Lite Hardware Setup
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from