ADP1974-EVALZ User Guide
UG-883
Rev. 0 | Page 3 of 12
TYPICAL SETUP FOR OPEN-LOOP EVALUATION
OSCILLOSCOPE
MULTIMETER
USE JUMPERS TO CONFIGURE
EN AND MODE OR
CONNECT EXTERNAL POWER
SUPPLIES TO CENTER PINS
GROUND CONNECTION FOR
EXTERNAL EQUIPMENT
AND SYSTEM GROUND
POWER SUPPLY
V
IN
= 6V TO 60V
POWER SUPPLY
V
FAULT
= 6V TO 60V
POWER SUPPLY
V
COMP
= 0V TO 5V
GROUND CONNECTION
FOR EXTERNAL EQUIPMENT
AND SYSTEM GROUND
13517-
001
CONNECT AN OSCILLOSCOPE
IF SYNC IS CONFIGURED
AS AN OUTPUT
CONNECT TO AN EXTERNAL
CLOCK SIGNAL FOR SYNCHRONIZATION
IF SYNC IS CONFIGURED AS AN OUTPUT
SELECT R
S
FOR A DESIRED CURRENT LIMIT
OR CONNECT CL TO GND FOR EVALUATION
Figure 1.
