Installing the MXR-1001
18
MXR-1001 - Installation & Hardware Reference Manual
5) Connect Ethernet, USB and Power Cables
Once the MXR-1001 is installed, plug in the Power, Ethernet and (optionally) USB cable(s). These connectors are all located on the
rear panel of the Motor chassis.
Power (3-Pin Captive Wire):
Connect to the included PSR2.5 24VDC external power supply. For pinout information on this
connector, refer to the
MXR-1001 Hardware Installation Guide.
Ethernet (RJ45)
: Use a CAT5 Ethernet cable to connect the MXR-1001 to a Gigabit Ethernet Switch. For information on
pinouts, signals, and LED blink patterns for this connector, refer to the
MXR-1001 Hardware Installation Guide.
NOTE:
Clip the included snap-on cable Ferrite onto the Ethernet cable as close as possible to the Ethernet (RJ45) connector on
the rear panel.
USB (Type A, x2)
: For firmware upgrades, touch panel file transfers, JPEG image viewer, and HID Peripherals.
NOTE:
If the MXR-1001 is not connected to a Master, the physical pushbutton can still be used to raise/lower the panel.
FIG. 16
MXR-1001 - Installed (side view)
mounting
Mounting Clamp (x4)
(2 on each side)
front
surface
Rubber Foot
Thumb Screw
Release Tab
Clamp Slot (x4)
(2 on front/rear panels
of the Motor chassis)
Motor
chassis