AMX MXD-430, Инструкция по эксплуатации

Страница: 69 / 86

Installing Wall-Mount (MXD) Panels
63 Modero X® Series G4 Touch Panels Instruction Manual
FIG. 45 shows the MXD-700 Backbox installation:
4.
Remove any knockouts as needed on either long dimension of the Backbox to facilitate incoming wiring and pull
the wiring through the resultant holes.
5.
Push the Backbox into the mounting surface. Insure that the locking tabs lie flush against the Backbox and that the
Backbox goes freely into the opening.
6.
Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.

Not all of the tabs must be extended to lock the Backbox in place, but extending a minimum of the top and
bottom tabs is highly recommended.

Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs
will tighten up against the inside of the wall.

The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,
as well as in assisting with removal if necessary.

For additional strength, #4 mounting screws (not included) may be secured through circular holes located at
the left and right sides of the panel (FIG. 44, FIG. 45). In order to prevent damage to the touch panel, make
sure that these are flush with the Backbox.
7.
Insert each connector into its corresponding location along the back of the panel.
a.
To reach the RJ45 connector, gently pull it from beneath the electronics cover.
b.
Attach the Ethernet cable and gently push the connection back under the cover.
FIG. 45 MXD-700 Backbox Installation (Landscape)
#4 Screws
4X Knock-Outs
Remove for Cable
Routing as Needed
2X Installation Clamp
for Wall Thickness
.37 [12.03] to .98 [.25.0]
The maximum recommended torque to screw in the locking tabs on the plastic
Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab
screws, such as with powered screwdrivers, can strip out the locking tabs or damage
the plastic Backbox.
Refer to the Power via PoE section on page 65 for details on PoE and Ethernet Cable
Installation and Modification.