AMX MXD-430, Инструкция по эксплуатации

Страница: 58 / 86

Installing Wall-Mount (MXD) Panels
52 Modero X® Series G4 Touch Panels Instruction Manual
3.
Thread the incoming power and Ethernet wiring from their terminal locations through the surface opening
(FIG. 31).
Note that FIG. 31 shows the MXD-1900L-PAN, but the illustration applies equally to the MXD-2000XL-PAN.
Also note that FIG. 31 shows a landscape panel but the installation of a portrait panel is essentially the same, other
than the vertical orientation.
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
4.
Remove any knockouts as needed on either long dimension of the Backbox to facilitate incoming wiring and pull
the wiring through the resultant holes.
5.
Push the Backbox into the wall opening. Insure that the locking tabs lie flush against the Backbox, and that the
Backbox goes freely into the opening.
6.
Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.
Making sure that the actual cutout opening is slightly smaller than the provided
dimensions is highly recommended. This action provides the installer with a margin
for error if the opening needs to be expanded. Too little wall material removed is
always better than too much.
FIG. 31 MXD-1900L-PAN Backbox installation (Landscape)
4X Installation Clamp
for Wall Thickness
.37 [12.01] to .98 [25.0]
Cables Routed to
Wall Opening
8X Knock Outs
Remove For Cable
Routing As Needed
Mounting screws
placement (optional)
Wall
Note:
Additional detailed installation and product drawings are available to view/download at www.amx.com
The maximum recommended torque to screw in the locking tabs on the plastic
Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab
screws, such as with powered screwdrivers, can strip out the locking tabs or damage
the plastic Backbox.