AMX Modero ViewPoint MVP-7500, Руководство по эксплуатации/справочник, Страница: 46 / 210

Configuring Communications
36 MVP-7500/8400 Modero Viewpoint Wireless Touch Panels
4.
Click the Communications Settings button to open the Communications Settings dialog.
5.
Click on the NetLinx Master radio button ( from the Platform Selection section ) to indicate that you
are working as a NetLinx Master.
6. Click on the Virtual Master radio box ( from the Transport Connection Option section ) to indicate
you are wanting to configure the PC to communicate with a panel. Everything else such as the
Authentication is greyed-out because you are not going through the Master’s UI.
7.
Click the Edit Settings button ( on the Communications Settings dialog ) to open the Virtual NetLinx
Master Settings dialog (FIG. 29).
8.
From within this dialog enter the System number ( default is 1 ) and note the IP Address of the target
PC being used as the Virtual Master. This IP Address can also be obtained by following these
procedures:
On your PC, click Start > Run to open the Run dialog.
Enter cmd into the Open field and click OK to open the command DOS prompt.
From the C:\> command line, enter ipconfig to display the IP Address of the PC. This
information is entered into the Master IP/URL field on the panel.
9. Click OK three times to close the open dialogs, save your settings, and return to the main NetLinx
Studio application.
10.
Click the OnLine Tree tab in the Workspace window to view the devices on the Virtual System. The
default System value is one .
11.
Right-click on the Empty Device Tree/System entry and select Refresh System to re-populate the
list.
12.
Connect the terminal end of the PS4.4 power cable to the 12 VDC power connector on the side of
the stand-alone touch panel.
If the MVP is installed onto a docking station, feed power to the docked panel by connecting
the appropriate power supply to the docking station.
13.
After the panel powers-up, press and hold the two lower buttons on both sides of the display ( for 3
seconds ) to continue with the setup process and proceed to the Setup page.
14. Select Protected Setup > System Settings (located on the lower-left) to open the System Settings
page (FIG. 30).
FIG. 29 Assigning Communication Settings and TCP/IP Settings for a Virtual Master
Enter this IP
into the
Master IP/URL
field on the
System Settings
page
IP Addresses of computer
(also obtained by using the
Start > Run > cmd command)