AMX Modero ViewPoint MVP-7500, Руководство по эксплуатации/справочник, Страница: 34 / 210

Configuring Communications
24 MVP-7500/8400 Modero Viewpoint Wireless Touch Panels
4.
Select a desired Access Point by touching the corresponding row. The up arrow and down arrow
will be grayed out if there are ten or less access points detected. If there are more, then they will be
enabled as appropriate so that the user can scroll through the list.
5.
With the desired WAP selected and highlighted, click the Connect button to be directed to the
selected security mode’s Settings page with the SSID field filled in. You can then either Cancel the
operation or fill in any necessary information fields and then click Save .
If you select an Open, WEP, and WPA-PSK Access Point and then click Connect , you will be flipped
to the corresponding Settings page. For any other security mode, if you click Connect you will only
return to the previous page without any information being pre-filled out for you.
In an Open security mode, when a target WAP is selected and the connect to, the SSID name
of the selected WAP is saved for the open security mode.
In a Static WEP security mode, when a WEP Access Point is selected and then connected to,
the user is then redirected back to the Static WEP security screen where the
SSID field is
already filled out and the user is only required to enter in the remaining WEP key settings.
A similar process occurs for WPA-PSK access points. For any other case, the firmware
switches back to the previous page and security and connection parameters must be entered in
as normal.
Step 2: Configure the Card’s Wireless Security Settings
The second step to successfully setting up your wireless card is to configure the Wireless Settings section
of the Wireless Settings page. This section configures both the communication and security parameters
from the internal wireless card to the WAP.
The procedures outlined within the following sections use
an 802.11g card to configure a common security configuration to a target WAP.
Refer to either the G4 Web Control Settings/G4 Web Control Page section on page 80 or the Appendix B
- Wireless Technology section on page 183 for more information on the other security methods.
Once you have set up the wireless card parameters, you must configure the communication parameters
for the target Master; see
Step 3: Choose a Master Connection Mode section on page 31.