AMX Enova AVX-400, Руководство по эксплуатации/справочник, Страница: 29 / 50

Configuration
21 AVX-400 Enova Twisted Pair Presentation Switcher Operation/Reference Guide
Setting the Inactive Display Power Down
You can use the DCS software to set an amount of time for a display to be inactive before it shuts down to save power.
There must be no active inputs on the AVX-400 for the display power down to occur. This feature is not available for
HDMI input sources. Perform these steps to set the inactive display power down:
1.
Click the Display tab on the AMX DCS window.
2.
Enable display control. See the Enabling Display Control section on page 20 for more information.
3.
Use the Hours , Minutes , and Seconds sliders to indicate the amount of time you want the display to be inactive
before powering down.
4.
Click Program Device for the changes to take effect.
Setting the Communication Speed
The AVX-400 enables you to set the communication speed between DCS and the AVX-400. DCS sets the speed that is
applicable for the firmware version of the AVX-400, but it also allows you to override the speed setting. Default speed is
supported by all firmware versions, but High speed is only supported by firmware version 2.0 or higher.
You can change the communication speed by selecting COM Speed - Default or COM Speed - High from the Tools
menu.
Device Library Manager
The Device Library Manager (FIG. 30) enables you to add, import, and modify information about individual devices you
can configure with DCS software. You can modify the device's serial connection settings and provide hexadecimal
values, where needed, for executable and status commands. The Device Library Manager is accessible by selecting
Device Library Manager from the File menu on the main DCS window.
FIG. 30 Device Library Manager