AMX Enova AVX-400, Руководство по эксплуатации/справочник, Страница: 14 / 50

Wiring and Device Connections
6 AVX-400 Enova Twisted Pair Presentation Switcher Operation/Reference Guide
The following table lists the pinouts, signals, and pairing associated with the Source Input connector.
When connecting to a wall input plate, use Cat5/5e/6 cable to connect from the source input on the switcher to the RJ-45
connector on the wall input plate (FIG. 6).

Wallplate cabling is suitable for use within a 1-50m range (3.2'-165'), however, you can possibly work outside
this range by using a low skew cable.

Do not use nanoskew cable, as the cable can cause audio data bleeding into the video.
FIG. 5 Source Inputs
Use Cat5/5e/6 cable only for the source input connections. Using Cat5 crossover
cable may damage the presentation switcher.
You can use only one HDMI pass-through wallplate per AVX-400.
Source Input Wiring
RJ45
Pin #
568A
Termination A/V Signals
568B
Termination
Color Pair # RGB YPbPr CVBS S-Video Color Pair #
1 3 Red + Y + CVBS S1 + Y + 2
2 3 Red - Y - CVBS S1 - Y - 2
3 2 Blue + Pr + CVBS S3 + C + 3
4 1 Green + Pb + CVBS S2 + 1
5 1 Green - Pb - CVBS S2 - 1
6 2 Blue - Pr - CVBS S3 - C - 3
7 4 Audio, Data, Power + Audio, Data, Power + Audio, Data, Power + Audio, Data, Power + 4
8 4 Audio, Data, Power - Audio, Data, Power - Audio, Data, Power - Audio, Data, Power - 4
FIG. 6 Wall input plate connector
Wall input plate RJ-45 connector
AMX has evaluated several types of category cable for use with UPX wall plates. Of
the cable types tested, CAT-5e offers optimal performance for UPX analog signal
routing and AMX recommends Belden part number 1583a for best performance.
CAT-6 category cable however has demonstrated wide variance in performance
across manufacturers and cable part numbers, and therefore AMX recommends that
customers needing to install CAT-6 cable pre-test the desired cable model with UPX
wall plates at the desired lengths prior to installation. AMX is currently evaluating
additional Cat-6 and Cat-7 model numbers for compatibility, and will publish
recommended model numbers upon results of the evaluation.